©2018 by Zach Pfeffer


Integrate SWUpdate into a PetaLinux Project

April 16, 2018

 This post lists steps to integrate SWUpdate into a PetaLinux Project.


The results have not been thoroughly tested. 




1. Clone the SWUpdate meta layer into ext_source:


2. Download these patches to the meta-swupdate directory


3. Apply the patches:


4. Follow the instructions for adding a layer listed in link (but use meta-swupdate instead of the example) and add the following to project-spec/meta-user/conf/petalinucbsp.conf:


You should have approximately these diffs once you're done:


5. Type petalinux-build and test.








You'll get SWUpdate 2017.1 with this method. Take a look at this link to see how to figure this out.

Please reload

Our Recent Posts

Army 20.1 SBIR TABA Funding Clarification: is $5k "On Top" of the $167,500 Available?

February 18, 2020

Contents of DoD SBIR/STTR 20.1 Cost Volume Info Pop-Ups: Fringe Benefits, Fully Loaded Labor Rate, etc. and Labor Categories

February 9, 2020

Finding Resources for Learning about Fringe, Overhead and General Management and Administration (G&A) Cost Allocation for Army SBIR Proposals

February 8, 2020

Please reload


Please reload